Speco Technologies DVR-IP4CF Bedienungsanleitung PDF herunterladen (Seite 29)

DVR-IP4CF

to trigger the alarm when hard disk is full (this setup is only active when the

system is under record status).

9. BUZZER TIME: Press《ENTER》button to setup the buzzer time to continuous

(CONT), and press any button to release this setup.

10. RELAY OUT TIME: Press《ENTER》button to setup the relay out time to

continuous (CONT), and press any button to release this setup.

8.5.1 SENSOR TYPE:

1. Cursor (>) position indicates the current selected position.

2. Press《←》and《→》button to move the cursor to the desired item (CH1~CH4).

3. Press《ENTER》button to make changes.

4. Press《MENU》button to exit “SENSOR SETUP” selection.

5. CHANNEL-1: Press《ENTER》button to setup “NO” (Normal Open) or

“NC” (Normal Close).

6. CHANNEL-2 ~ CHANNEL-4: Please follow the setup shown above (CHANNEL-1).

SENSOR SETUP ■■■

> CHANNEL-1 NOT INSTALLED

CHANNEL-2 NOT INSTALLED

CHANNEL-3 NOT INSTALLED

CHANNEL-4 NOT INSTALLED

PRESS (< >), THEN (ENTER)

PRESS (MENU) TO EXIT

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 64 65

Keine Kommentare

Speco Technologies DVR-IP4CF Bedienungsanleitung Seite 29